The daily maintenance of the aluminum wire drawing machine is the key to ensure its efficient and stable operation. The following are detailed maintenance steps and recommendations:
1. Daily cleaning and maintenance
1. Equipment cleaning: regularly clean the surface of the machine to avoid dust, oil and other impurities attached to the equipment, affecting the normal operation of the equipment.
2. Clean the transmission part: clean the transmission parts and chains, and spray a layer of anti-rust maintenance oil on the surface to prevent rust and wear.
3. Clean the servo motor: use a clean cotton cloth or brush to clean the servo motor to avoid water or moisture entering the motor.
4. Clean the coil machine and control panel: clean the coil machine and control panel, remove impurities on the socket, and wipe with a clean cloth to keep it clean and tidy.
Two, lubrication maintenance
1. Lubricating the transmission part: After each use, apply a layer of oil on the transmission part to prevent rust and wear.
2. Lubricate the servo motor: spray a layer of oil on the servo motor to maintain its normal operation.
3. Lubricate the winding machine: Apply a layer of fine lubricating oil on the pulley, guide wheel and bearing of the winding machine to reduce friction and wear:
4. Clean the coil machine and control panel: clean the coil machine and control panel, remove impurities on the socket, and wipe with a clean cloth to keep it clean and tidy.
Two, lubrication maintenance
1. Lubricating the transmission part: After each use, apply a layer of oil on the transmission part to prevent rust and wear.
2. Lubricate the servo motor: spray a layer of oil on the servo motor to maintain its normal operation.
3. Lubricate the winding machine: Apply a layer of fine lubricating oil on the pulley, guide wheel and bearing of the winding machine to reduce friction and wear.
Three, electrical maintenance
1. Check electrical wiring joints: Regularly check all wire joints and sockets are loose or damaged to ensure the normal operation of the electrical system.
2. Check the electrical components: check whether the electrical components are clean and check whether the voltmeter and electrical signal are operating normally.
3. Clean the dust collection box: clean the dust collection box regularly to prevent dust accumulation from affecting the normal operation of electrical components.
Four, safety maintenance
1. Check the safety protection device: such as protection device, emergency stop button, etc., to ensure the safe operation of the equipment.
2. Precautions for operation: During operation, follow the operating rules and safety operating rules of the equipment to prevent equipment damage or personal injury caused by improper operation.
5. Other maintenance items
1. Maintain the tension of the belt of the wire drawing machine: check the tension of the belt during the normal operation of the wire drawing machine, and adjust it as needed.
2. Replace the filter: Replace the filter every six months according to the instructions to replace the filter to ensure the filtration effect of the equipment.
3. Environmental control: The wire drawing machine is stored in a dry, well-ventilated and suitable temperature environment to ensure its life: By regularly implementing the above maintenance measures, you can ensure the normal operation of the aluminum wire drawing machine and extend its service life. During daily use, follow the operation rules and safety regulations to prevent equipment damage or personal injury caused by improper operation.